Control Gaging :: Industrial Electronic Repair

Links Menu

Home
About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Forum
Forum2
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing

Manufacture:

Part #:



Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info
1-336-969-0110

  
tagged Comments
Control Gaging
  Posted by Eric Johnson on Tuesday, December 31 2024

#ControlGaging

I had a mouse problem chewing on the wires. I replaced all chewed wires. I (purchase 2 used monitors) on eBay and tested them. #1 - model 760 and #2 - model 852.
Both of them: the (-) button is not functioning when pressed. The fault light indicates #6 on the meter which suggest a bad wire / cable. When the monitor is first powered on (all the lights flash) as they should. I was able to press the (+) adjustment and it functioned as it should, but the (-) button will not light up or work as it should. I would like to send these monitors in to have tested or repaired as long as the cost is reasonable. There are a few testing facilities I found online for these units. can you give me a cost of testing them?

I have one more monitor #3 model 760 in like new condition that I (purchased used). When I tested it, the monitor flashed all lights and then went straight to the fault setting and no functions worked at all. The other 2 monitors I was at least able to put in calibrate mode / "0" / and operate the firing point sequence but not able to work the (-) button.

Please advise.

Thank you

Eric


  Current thread:

Currently there are no responces to this post.

Suggested Tagged Message

View Tagged Message

Return Home
to Control Gaging Repair
*Tagged Manufactures Control Gaging

*Tagged List
Need to get your
Control Gaging Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate

Contact Shop 1-336-969-0110


If you need your Control Gaging unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of Control Gaging units.
Reply to the Message Below!
OLD Topic: Repair of Control Gaging ControlGaging
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Subject:
Comment about
Control Gaging:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!
Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  


    • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.


    Teijin Seiki Servo Drive
    Teijin Seiki


    NSK Servo Drive
    NSK


    Etasis Power Supply
    Etasis



    Vickers Servo Drive Repair




    Nikki Denso Servo Drive Repair
    Board Repair
    Forum
    Parts



    Hosted by

    ABCDEFGHIJKLMNOPQRSTUVWXYZ
    IERNC Created this page in 0.099094 seconds