Evco Evco Products :: Industrial Electronic Repair

Links Menu

Home
About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Forum
Forum2
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing

Manufacture:

Part #:



Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info
1-336-969-0110

  
Evco Products

  Posted by Katie Sunderman on Thursday, October 20 2016

I am the owner of an installed Evco Chandelier Lift (circa 1997/1998) w/ 1200 watts of power, model #RL-0941-1 with a key switch 150lb capacity, 8ft. travel.

We appreciate your technical input to remedy a fairly simple problem, that we hope to fix.

The 4 wires to the key switch have pulled out of the termination points behind the switch plate and we are not sure of which wires should attach back into each termination point (numbers on each wire as follow: 1-8). We have the wiring schematic with the original manufacturers material, but a verification from your professional technical staff would be so helpful!

Could you please indicate which termination point each of the removed 4 wires should be re-inserted?

Thank you for your courtesy,
Katie



  Current thread:

Currently there are no responces to this post.

tagged Comments
Evco Products

  Posted by Tim Downey on Saturday, September 12 2015

I have a chandelier lift with an EVCO product ATP 0894 which was damaged when too high of wattage light bulbs were placed in the chandelier. The lift works but the lights won't turn on. An electrician found the problem in the 0894 but told me it couldn't be fixed and a new product could not be purchased. It appears 2 small metal posts are burned, one of them at the "motor reel - black" post and then the line and post to the first small black box which his numbered 252XAXH-12D. Any advice would be greatly appreciated, i.e., can it be fixed and can I buy a new one if not. Thanks. Tim Downey.



  Current thread:

Evco Products
Evco Products

View Parent Message

View Manufacture

Return Home
to Evco Repair

*Tagged Manufactures EVCO

*Tagged List
Need to get your
EVCO Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate


Contact Shop 1-336-969-0110



If you need your EVCO unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of EVCO units.


Reply to the Message Below!
OLD Topic: Repair of EVCO dart
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Subject:
Comment about
Evco:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!

Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

  • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.


    Teijin Seiki Servo Drive
    Teijin Seiki



    NSK Servo Drive
    NSK


    Etasis Power Supply
    Etasis



    Vickers Servo Drive Repair




    Nikki Denso Servo Drive Repair

    Board Repair
    Forum
    Parts




    Hosted by

    ABCDEFGHIJKLMNOPQRSTUVWXYZ
    IERNC Created this page in 0.107327 seconds